Power-Inline Enable - Allied Telesis AT-8100L/8 User Manual

Chapter 12: Power Over Ethernet Commands

POWER-INLINE ENABLE

Syntax
power-inline enable
Parameters
None
Mode
Port Interface mode
Description
Use this command to enable PoE on the ports. This is the default setting.
Confirmation Commands
"SHOW POWER-INLINE" on page 282
"SHOW POWER-INLINE INTERFACE" on page 287
"SHOW POWER-INLINE INTERFACE DETAIL" on page 288
Example
This example enables PoE on port 12:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.12
awplus(config-if)# power-inline enable
276