Chapter 12: Power Over Ethernet Commands
SHOW POWER-INLINE INTERFACE DETAIL
288
Syntax
show power-inline interface
Parameter
port
Specifies a port. You can display more than one port at a time.
Mode
Privileged Exec mode
Description
Use this command to display additional information about the ports. An
example is shown in Figure 67.
Interface port1.0.1
Powered device type: Desk Phone #1
PoE admin enabled
Priority Low
Detection status: Powered
Current power consumption: 00 mW
Powered device class: 1
Power allocated: 5000 mW (from configuration)
Detection of legacy devices is disabled
Figure 67. SHOW POWER-INLINE INTERFACE DETAIL Command
The fields are described in Table 26.
Table 26. SHOW POWER-INLINE INTERFACE DETAIL Command
Field
Interface
Powered device
type
port
detail
Description
The port number.
The PD description. The description is set with
"POWER-INLINE DESCRIPTION" on page 275.