Chapter 12 : Power Over Ethernet Commands - Allied Telesis AT-8100L/8 User Manual

Chapter 12
Power Over Ethernet Commands
Command
"CLEAR POWER-INLINE
COUNTERS INTERFACE" on
page 265
"NO POWER-INLINE ALLOW-
LEGACY" on page 266
"NO POWER-INLINE DESCRIPTION"
on page 267
"NO POWER-INLINE ENABLE" on
page 268
"NO POWER-INLINE MAX" on
page 269
"NO POWER-INLINE PRIORITY" on
page 270
"NO POWER-INLINE USAGE-
THRESHOLD" on page 271
"NO SERVICE POWER-INLINE" on
page 272
"NO SNMP-SERVER ENABLE TRAP
POWER-INLINE" on page 273
"POWER-INLINE ALLOW-LEGACY"
on page 274
"POWER-INLINE DESCRIPTION" on
page 275
"POWER-INLINE ENABLE" on
page 276
"POWER-INLINE MAX" on page 277
The Power over Ethernet (PoE) commands are summarized in Table 23.
These commands are only supported on the PoE switches.
Table 23. Power over Ethernet Commands
Mode
Privileged Exec
Port Interface
Port Interface
Port Interface
Port Interface
Port Interface
Global
Configuration
Global
Configuration
Global
Configuration
Port Interface
Port Interface
Port Interface
Port Interface
Description
Clears the PoE event counters on the
ports.
Configures ports to deny power to
legacy powered devices (PDs).
Deletes the PD descriptions.
Disables PoE on the ports.
Restores a port's power limit to the
default value.
Restores a port's priority setting to the
default Low level.
Resets the power usage threshold to
the default 80%.
Disables PoE on all of the ports on the
switch.
Disables the SNMP power-inline trap.
Configures a port to support legacy
PDs.
Adds a PD description to a port.
Enables PoE on a port.
Specifies the power limit of a port.
263