Disabling Enhanced Stacking - Allied Telesis AT-8100L/8 User Manual

AT-8100 Switch Command Line User's Guide

Disabling Enhanced Stacking

The command that disables enhanced stacking on a switch is the NO
ESTACK RUN command in the Global Configuration mode, and the
confirmation command is the SHOW ESTACK command in the Privileged
Exec mode.
You may not use the NO ESTACK RUN command when you are
managing a member switch through enhanced stacking. You may only use
the command when you are managing a switch directly, from a local
management session or a remote Telnet, SSH, or web browser session.
When you disable enhanced stacking on a command switch, you may not
use the switch to manage the member switches of an enhanced stack. It
should be noted that disabling enhanced stacking on a command switch
returns the mode to the member switch mode. So if you reactivate
enhanced stacking, the switch is a member switch, unless you change it
again with the ESTACK COMMAND-STACK command.
Here is the command:
awplus> enable
awplus# configure terminal
awplus(config)# no estack run
429