Displaying The On-Line Help - Allied Telesis AT-8100L/8 User Manual

Displaying the On-line Help

awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# flowcontrol ?
The command line interface has an on-line help system to assist you with
the commands. The help system is displayed by typing a question mark.
Typing a question mark at a command line prompt displays all the
keywords in the current mode. This example displays all the keywords in
the VLAN Configuration mode.
awplus> enable
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# ?
convert
do
end
exit
help
no
private-vlan
quit
vlan
with a single VLAN
Figure 28. Displaying the Keywords of a Mode
Typing a question mark after a keyword displays any additional keywords
or parameters. This example displays the available parameters for the
FLOWCONTROL command in the Port Interface mode.
both
receive
send
Figure 29. Displaying Subsequent Keywords of a Keyword
Note
You must type a space between the keyword and the question mark.
Otherwise, the on-line help system simply displays the previous
keyword.
Typing a question mark at the point in a command where a value is
required displays a value's class (that is, integer, string, etc.). The example
in Figure 30 on page 84 displays the class of the value for the
HOSTNAME command in the Global Configuration mode.
Convert vlan
To run exec commands in config mode
End current mode and down to privileged mode
End current mode and down to previous mode
Description of the interactive help system
Negate a command or set its defaults
Private-vlan
End current mode and down to previous mode
Add, delete, or modify values associated
Flow control on send and receive
Flow control on receive
Flow control on send
AT-8100 Switch Command Line User's Guide
83