Power-Inline Description - Allied Telesis AT-8100L/8 User Manual

POWER-INLINE DESCRIPTION

Syntax
power-inline description
Parameters
description
Specifies a PD description of up to 256 alphanumeric characters.
Spaces and special characters are allowed.
Mode
Port Interface mode
Description
Use this command to add PD descriptions to the ports to make the ports
and PDs easier to identify.
Note
To add a general description to a port, use the DESCRIPTION
command. For more information, see "DESCRIPTION" on page 204.
Confirmation Commands
"SHOW POWER-INLINE" on page 282
"SHOW POWER-INLINE INTERFACE" on page 287
"SHOW POWER-INLINE INTERFACE DETAIL" on page 288
Example
This example adds the PD description "Surveillance Camera5" to port 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# power-inline description Surveillance
Camera5
AT-8100 Switch Command Line User's Guide
description
275