Overview; Table 27. Features Requiring An Ip Management Address On The Switch - Allied Telesis AT-8100L/8 User Manual

Chapter 13: IPv4 and IPv6 Management Addresses

Overview

Table 27. Features Requiring an IP Management Address on the Switch

Feature
802.1x port-based network
access control
Enhanced stacking
Ping
RADIUS client
294
This chapter explains how to assign the switch an IP address. The switch
must have an IP address to perform the features in Table 27. It uses the
address as its source address when it communicates with other network
devices, such as TFTP servers, and Telnet management workstations.
To assign an IP address to the switch, you have to create an IPv4 routing
interface in one of its VLANs. You should assign the routing interface to
the VLAN from which the switch is to access the management devices.
The switch uses the IP address of the routing interface as its source
address.
Routing interfaces are also used to implement the IPv4 packet routing
feature, described in Chapter 104, "Internet Protocol Version 4 Packet
Routing" on page 1807. If you do not plan to use the packet routing
feature, create only one IPv4 routing interface on the switch. The switch
does not route packets if it has only one interface.
You may also assign the switch one IPv6 management address. However,
as the table indicates, the switch does not support all of the features when
assigned only an IPv6 address.
Used with a RADIUS server for
port security.
Used to manage more than
one switch from the same local
or remote management
session.
Used to test for valid links
between the switch and other
network devices.
Used for remote management
authentication and for 802.1x
port-based network access
control.
Description
Supported Supported
by IPv4 by IPv6
Address Address
yes no
yes no
yes yes
yes no