Managing The Member Switches Of An Enhanced Stack - Allied Telesis AT-8100L/8 User Manual

Chapter 23: Enhanced Stacking

Managing the Member Switches of an Enhanced Stack

numOfNodes 2
Num Mac Address
-------------------------------------------------------------------------
01 eccd.6d4d.6dd5
02 eccd.6d4d.6dd0
416
Here are the steps on how to manage the member switches of an
enhanced stack.
1. Start a local or remote management session on the command switch
of the enhanced stack. After logging on, you can view and configure
the settings of just the command switch.
2. To manage a member switch in the enhanced stack, enter the SHOW
ESTACK REMOTELIST command in the Privileged Exec mode.
awplus> enable
awplus# show estack remotelist
This command displays all of the member switches in the stack. It
does not display any command switches, including the command
switch on which you started the management session. An example is
shown here.
Name
dutC
dutB
Figure 96. SHOW ESTACK REMOTELIST Command
3. Use the RCOMMAND command in the Global Configuration mode to
redirect the management session from the command switch to one of
the member switches in the list. The format of the command is shown
here:
switch_id
rcommand
For example, to manage the dutB switch in the list, you would enter
this command:
awplus# configure terminal
awplus(config)# rcommand 2
You can manage just one member switch at a time.
4. When prompted, enter the login name and password of a manager
account on the member switch you are accessing. Once you have
logged on, the command prompt for the member switch is displayed.
5. Configure or view the settings of the member switch, as needed.
Mode Version
Member AWPLUS v2.2.5.0 AT-8100S/24
Member AWPLUS v2.2.5.0 AT-8100S/24C
Model