Show Ip Dhcp-Relay; Table 48. Show Ip Dhcp-Relay Command - Allied Telesis AT-8100L/8 User Manual

SHOW IP DHCP-RELAY

Syntax
show ip dhcp-relay [interface
Parameters
vlanid
Specifies a VLAN ID number, such as vlan1. You may specify only
one VLAN.
Mode
Privileged Exec mode
Description
Use this command to view the settings of the DHCP relay agent.
Figure 106 is an example of the information.
DHCP Relay Service is enabled
List of Interfaces:
Maximum hop count is 10
Maximum DHCP message length is 576
Insertion of Relay Agent Option is disabled
Checking if Relay Agent Option is disabled
Relay Information policy is to replace existing relay
agent information.
List of servers: 149.187.132.21, 149.187.132.56
Figure 106. SHOW IP DHCP-RELAY Command
The fields are defined in Table 48.

Table 48. SHOW IP DHCP-RELAY Command

Field
DHCP Relay
Service
Maximum hop
count
AT-8100 Switch Command Line User's Guide
vlanid
]
Definition
The enabled or disabled status of the agent. The
status is controlled with "SERVICE DHCP-
RELAY" on page 502 and "NO SERVICE DHCP-
RELAY" on page 501.
The hop count for discarding DHCP request
messages from clients. The parameter is
controlled with "IP DHCP-RELAY MAXHOPS" on
page 495.
503