Exec-Timeout - Allied Telesis AT-8100L/8 User Manual

Chapter 8: Basic Switch Management Commands

EXEC-TIMEOUT

148
Syntax
value
exec-timeout
Parameters
exec-timeout
Specifies the session timer in minutes. The range is 0 to 35,791
minutes. The default value is 10 minutes.
Mode
Line Console and Virtual Terminal Line modes
Description
Use this command to set the management session timers. The timers are
used by the switch to end inactive management sessions to protect
against unauthorized changes should you leave your management station
unattended during a management session. A management session is
deemed inactive by the switch if there is no management activity for the
duration of a timer.
Local management sessions, which are conducted through the Console
port on the switch, and remote Telnet and SSH sessions have different
timers. The timer for local management sessions is set in the Line Console
mode. The timers for remote Telnet and SSH sessions are set in the
Virtual Terminal Line mode. There is a different timer for each of the ten
VTY lines for remote Telnet and SSH sessions.
Confirmation Commands
"SHOW SWITCH" on page 165 and "SHOW RUNNING-CONFIG" on
page 164
Examples
This example sets the session timer for local management sessions to 15
minutes:
awplus> enable
awplus# configure terminal
awplus(config)# line console 0
awplus(config-line)# exec-timeout 15