Table of Contents
Advertisement
v Connect an Ethernet cable to the RJ-45 management port and use Telnet,
v Connect the mini-USB console cable to the RS-232 serial port on the switch
The console port terminal-emulation requirements are as follows:
v Default baud rate = 9,600 bps
v Character size = 8 characters
v Parity = none
v Stop bits = 1
v Data bits = 8
v Flow control = none
The switch performs initial self tests, and displays the password prompt, similar to
the following screen:
At the Password prompt, enter the switch password, and press Enter. The default
password is admin.
Default configuration
The switch software contains default configuration files that are loaded at the
factory. The default configuration is part of the software; it cannot be deleted or
changed. The default settings allow the switch to perform basic functions with
minimal effort by the system administrator.
Configuring an IP interface
To manage the switch using Telnet, SNMP, or a web browser, you must configure
an IP interface. Configure the following IP parameters:
v IP address
v Subnet mask
v Gateway address
1. Log on to the switch.
2. Enter IP interface mode.
3. Configure an IP interface, subnet mask, and VLAN assignment. Enable the
SNMP, or a Web browser to access the CLI through the IP address provided by
the network's DHCP server.
unit's front panel, and use a terminal or a computer running a terminal emulation
program to access the switch CLI.
Memory Test ................................
Production Mode
PPCBoot 0.0.0.10 (new flash)
Memory Test (0x00) .............................PASSED
...
IBM System Networking RS G8264CS
Jan 1 00:01:27 2012:
NOTICE-5:Interface Oper Status Indication - Port 7 State UP
Password:
RS G8264CS> enable
RS G8264CS# configure terminal
RS G8264CS (config)# interface ip 1
interface.
Chapter 2. Installing the RackSwitch G8264CS
27
Advertisement
Table of Contents
