Access Group Management - Samsung Ubigate iBG3026 Configuration Manual

CHAPTER 33. Routing and Digit Manipulation

Access Group Management

Introduction
Applying the call block function to determine whether it permits call or not
based on Ip address prior to inbound dial peer matching against VoIP
incoming call is used. Executing classification function is possible by setting
Permit and deny. By managing list group with Ip address, authentication and
call block function can be made.
Configuring Access Group
See the below table when it comes to the method to set access group and
access list.
Configuration Steps
configure terminal
−
voice access-group
−
access-list
−
access-list-permit
−
access-list-deny(optional)
−
description(optional)
−
disconnect-cause(optional)
−
translation-profile(optional)
−
exit
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
2 voice access-group
Example)
sbm/configure# voice
access-group accgrp1
3 access-list num
Example)
sbm/... /access-group
name# access-list 0
594
Command Purpose
Enters global configuration mode.
Creates access group. The name of group
must be come up with in 31 letters.
Creates access list. Users can create 8 lists
ranging from 0 to 7
© SAMSUNG Electronics Co., Ltd.