Samsung Ubigate iBG3026 Configuration Manual page 596

CHAPTER 32. ISDN
Delete the ISDN
To delete the ISDN, use the following command
Step
1 configure terminal
2 voice-port 0/0/0:D
3 shutdown
4 No interface bundle
WORD
Configuring ISDN Calling Number Identification
A router might need to supply the ISDN network with a billing number for
outgoing calls. Some networks offer better pricing on calls in which the
number is presented. When configured, the calling number information is
included in the outgoing Setup message.
To configure the interface to identify the billing number, use the following
command in interface configuration mode:
Step
1 configure terminal
2 Interface bundle
bundle-name
3 Link [pri_t1|pri_e1]
0/0/0:1
4 isdn
5 Switch-type switch-type
6 Incoming-voice
7 Calling-number calling-
number
8 activate
554
Command
Configures to set up bundle.
Configures to set up voice-port.
Shutdown voice port..
Delete interface bundle
Command
Configures to set up bundle.
Sets up bundle name.
Sets up the pertinent physical link.
Sets up ISDN
Sets up the pertinent switch-type with the
content like the following table.
Sets up for voice.
Specifies the calling party number
Activates ISDN.
Purpose
Purpose
© SAMSUNG Electronics Co., Ltd.