Samsung Ubigate iBG3026 Configuration Manual page 616

CHAPTER 33. Routing and Digit Manipulation
Configuring Voice Class Sip/H323
The voice class that you assign to the dial peer must be configured using the
voice-class sip/h323 in global configuration mode. You can assign one voice
class to each VoIP dial peer. If you assign another voice class to a dial peer, the
last voice class assigned replaces the previous voice class.
Followings are commands that could be configured in 'voice class sip' mode.
offer call-hold { conn-addr | dir-send | dir-inact }
Example)
sbm/configure/voice/class/sip num# offer call-
hold conn-addr
rel1xx { supported | require | system | disable }
Example)
sbm/configure/voice /class/sip num# rel1xx
supported.
uri { sip | sips }
Example)
sbm/configure/voice/class/sip num# uri sip
url { system | sip | tel }
Example)
sbm/configure/voice/class/sip num# url sip
Followings are commands that could be configured in 'voice class h323' mode.
h225 call-start {fast|slow|system}
h225 early-h245 {on|off|system}
574
Command
Command
Purpose
(optional) Specifies the call hold
request value.
(optional) Specifies the rel1xx
value.
(optional) Specifies the uri value.
(optional) Specifies the url value.
Purpose
Specifies the H.323 call setup
method.
Specifies whether to perform the
normal H.245 procedure before or
after CONNECT message.
© SAMSUNG Electronics Co., Ltd.