Table 29.7 Combination To Enable Or Shutdown H.323 Service - Samsung Ubigate iBG3026 Configuration Manual

CHAPTER 29. H.323 Gateway Management
Shutting Down and Enabling H.323 Services
This section describes the basic configuration necessary for H.323 gateway
functions. Since it is essential for H.323 call signaling, it should be done
before other settings. This section also describes how to enable or disable
H.323 service.
Prerequisites for Enabling H.323 Services
Before enabling H.323 service, a source IP address should be set first using
Bind command or host ip-address command.
How to Enable or Shutdown H.323 service
There are two ways of enabling or shutting down H.323 service. One uses a
shutdown command in voip-gateway configuration mode, the other one uses a
shutdown command in h323-gateway configuration mode. The shutdown
command in a h323-gateway configuration mode enables or disables only the
h.323 service; and the shutdown command in a voip-gateway configuration
mode enables or disables not only H.323 service, but also SIP service, that is,
the entire voip call service.
When H.323 service is actually enabled or shut down, the Table29.7 below is
followed.
voip-gateway
shutdown
no shutdown
shutdown
no shutdown
1.
shutdown in voip-gateway configuration mode
The procedure to enable or disable all voip call services including H.323
service is as follows.
Configuration Steps
−
−
−
−
428

Table 29.7 combination to enable or shutdown H.323 Service

shutdown
shutdown
no shutdown
no shutdown
configure terminal
voip-gateway
[no] shutdown
exit
h323-gateway H.323 Service Status
disabled
disabled
disabled
enabled
© SAMSUNG Electronics Co., Ltd.