Samsung Ubigate iBG3026 Configuration Manual page 170

CHAPTER 16. MultiCast Protocols
Enabling DVMRP
Use the following command to enable DVMRP on an interface. Use this
command for each interface: ip dvmrp enable
For example:
Router# configure terminal Router/configure# interface
ethernet 1/1
Router/configure/interface/ethernet (1/1)# ip dvmrp enable
Router/configure/interface/ethernet (1/1)# exit
Router/configure# interface ethernet 2/1
Router/configure/interface/ethernet (2/1)# ip dvmrp enable
Router/configure/interface/ethernet (2/1)# exit
Verifying Configuration
Use the following commands to verify interface, neighbor, route, prune, and
DVMRP global state information. Note: For details on the commands used in
the following example, refer to the Ubigate iBG3026 Command Reference.
Interface Information
The show ip dvmrp interface command displays the interface information for
Router_C. For example:
Router_C# show ip dvmrp interface
Neighbor Information
The show ip dvmrp neighbor command displays the neighbor information for
Router_C. For example:
Router_C# show ip dvmrp neighbor
Route Information
The show ip dvmrp route command displays the route information for
Router_C. For example:
Router_C# show ip dvmrp route
132
© SAMSUNG Electronics Co., Ltd.