Samsung Ubigate iBG3026 Configuration Manual page 511

Step
5 dial-type {dtmf|mf}
6 ring number number
7 locale locale
8 timeouts timer-name timer-
value
© SAMSUNG Electronics Co., Ltd.
Command
Specifies the dialing method for outgoing calls
(FXO only) Specifies the maximum number of
rings to be detected before an incoming call is
answered by the router.
The default is 1.
Selects the two-letter locale for the voice call
progress tones and other locale-specific
parameters to be used on this voice port
The Default is us
ex) locale us
To change timeouts parameters
initial - Sets the number of seconds that the
system waits between the caller input of the
initial digit and the subsequent digit of dialed
string.
A valid entry is from 0 to 120. The default is 10
interdigit - Configures the number of seconds
that the system waits after the caller has input
the initial digit or a
subsequent digit of the dialed string. If the
timeout ends before the Destination is
identified, a tone
sounds and the call ends. This value is
important when using variable-length dial peer
destination patterns(dial plans).
The seconds argument is the
interdigit timeout wait time in seconds.
A valid entry is an integer from 0 to 120.
The default is 5.
ringing - Specifies the duration that the voice
port allows ringing to continue if a call is not
answered.
The range is from 0 to 60000.
The default is 180. 0 means infinity.
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
(Continued)
469