Configuring A H.323 Gateway - Samsung Ubigate iBG3026 Configuration Manual

Configuring a H.323 Gateway

This section describes how to configure the items below.
Prerequisites for Configuring H.323 gateways
Configuring H.323 Bind
Shutting Down and Enabling H.323 Services
Configuring Basic H.323 Services
Configuring Gateway RAS
Configuring Multiple Codecs
Configuring Enhanced H.323 Services
Prerequisites for Configuring H.323 Gateways
Before configuring the H.323 gateway, the followings should be done first.
IP network environment for operation
voice network module and voice-interface card installation
Configuration of H.323 Endpoint(Gateways, Gatekeepers, Proxies) to
interwork with
Establishing a network plan for the requirements and features of VoIP
network where H.323 gateway belongs.
Establishing a Call Routing Plan on H.323 Network
Configuring H.323 Bind
This section describes the H.323 bind feature. With this feature, you can
specify the source address of H.323 signaling, and the source address for
media stream as well. You can specify the interface by Bind command or
specify the IP address directly by host ip-address command.
Restrictions for H.323 Bind
The interfaces which you can specify as the source address of H.323 signaling
and media stream via Bind command are ethernet, bundle and loopback.
Prerequisites for H.323 Bind
You must shut down the VoIP service before executing Bind command or host
ip-address command. To execute the Bind command, it is necessary to set IP
address first to the interface to bind.
© SAMSUNG Electronics Co., Ltd.
Ubigate iBG3026 Configuration Guide/Ed.00
423