Samsung Ubigate iBG3026 Configuration Manual page 201

R1-RSVP-TE
Router# configure terminal
Router/configure# rsvp-trunk T1
Router/configure/rsvp-trunk# primary no-cspf
Router/configure/rsvp-trunk# primary path P1
Router/configure/rsvp-trunk# primary no-cspf
Router/configure/rsvp-trunk# primary bandwidth 10m
Router/configure/rsvp-trunk# primary setup-priority 6
Router/configure/rsvp-trunk# primary hold-priority 4
Router/configure/rsvp-trunk# primary include-any A
Router/configure/rsvp-trunk# primary include-any C
Router/configure/rsvp-trunk# secondary setup-priority 5
Router/configure/rsvp-trunk# secondary hold-priority 3
Router/configure/rsvp-trunk# to 192.168.0.90
Configuring Global Parameters
Some common parameters can be configured in the Router mode on the
RSVP-TE daemon. These parameters are global and affect all LSPs.
In the following example the interval between two consecutive hello messages
is set. The neighbor is defined by the neighbor command. Hello exchanges are
enabled only between explicitly configured neighbors(configure this router as
a neighbor on R2(IP address 10.10.23.60).
© SAMSUNG Electronics Co., Ltd.
eth 2/1
192.168.0.63
lo
10.10.23.0/24
eth 0/0
R1
eth 2/1
Figure 18.11 Configuring Globle Parameters
Ubigate iBG3026 Configuration Guide/Ed.00
192.168.0.60
lo
R2 eth 1/1
192.168.0.90
10.10.21.0/24
eth 0/1
lo
R3
eth 1/1
163