Samsung Ubigate iBG3026 Configuration Manual page 551

Step
4 country name
[use-defaults]
5
ani-digits
6 answer-signal
7 caller-digits
8 default
9 dnis-digits
10 invert-abcd
11 ka
12 kd
13 metering
14 nc-congestion
15 request-category
16 unused-abcd
17 exit
18 exit
© SAMSUNG Electronics Co., Ltd.
Command
Using the country default command, after setting
of the parameters as a default value used in a
specific country, and using the command of each
CLI, it is possible to tune each command.
Specifies the number of ANI digits expected to
be collected.
Specifies answer signal to be used which can be
group-A or group-B.
Specifies the number of digits needed to be
collected before it requests ANI.
Sets a command to its default setting.
Specifies the expected number of DNIS digits.
Specifies the inversion of the ABCD bits before
tx and after rx.
Specifies the KA signal code ranging from 1 to 15.
Specifies the KD signal code ranging from 1 to 15.
Specifies sending a metering pulse when the
gateway is making an outgoing call.
Specifies the noncompelled congestion signal.
DNIS digits to be collected before requesting a
line category.
Specifies unused ABCD bit values.
Exit the cas-custom configuration mode.
Exit the voice-port configuration mode.
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
(Continued)
509