Bundle Configuration - Samsung Ubigate iBG3026 Configuration Manual

Bundle Configuration

This section describes how to configure a bundle interface. The interface
bundle specifies the physical connection to be linked, an encapsulation
protocol(Layer 2) and, optionally, Layer 3 parameters.
Configuring a HSSI frame relay bundle
The following example creates a simple interface bundle utilizing the HSSI
interface and Frame Relay(Layer 2) parameters.
Configuring Step
Step
1
2
3
4
5
6
7
8
9
10
© SAMSUNG Electronics Co., Ltd.
Command
Router# configure terminal
Router/configure# interface bundle
[bundle name]
Router/configure/interface/bundle
[bundle name]# link hssi 1/0
Router/configure/interface/bundle
[bundle name]# encapsulation frelay
Router/configure/interface/bundle
[bundle name # fr
Router/configure/interface/bundle
[bundle name /fr#
Router/configure/interface/bundle
[bundle name /fr# pvc [channel number]
Router/configure/interface/bundle
[bundle name]/fr/pvc [channel number]#
ip address [IP address] { [bit mask] |
[number of bits for mask] }
Router/configure/interface/bundle
[bundle name /fr/pvc [channel
number]# end
Router# show interface {bundle
[bundle name] | bundles}
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Enters the terminal
configuration mode.
Sets a bundle interface. 'bundle
name' represents a specific
bundle interface to be
configured at the moment.
Links a HSSI interface to a wan
interface
Selects Frame Relay as an
encapsulation method.
Enters the frame relay prompt
for setting frame relay
parameters.
Selects a clock rate.
Sets a PVC channel number.
Channel range: 16 to 1022.
Sets an IP address for the
PVC.
Returns to the 'Router#'
prompt.
Shows configured information
of the bundle interface or all
bundle interfaces.
43