Samsung Ubigate iBG3026 Configuration Manual page 165

To set the RP static IP address to 10.10.1.1, enter:
Router/configure#ip pim rp-address 10.10.1.1
To set the flag for the RP to switch to the SPT for(S, G) upon receipt of the
first Register message(default: on). To turn on this feature, enter:
Router/configure#ip pim spt-threshold
To specify that the message checksum will be calculated over the entire
encapsulated packet, rather than just over the Register message header, enter:
Router/configure#ip pim cisco-register-checksum
To set the hello hold time to 60 seconds, enter:
Router/configure/interface/ethernet (1/0)# ip pim hello-
holdtime 60
To set the hello interval time to 145 seconds, enter:
Router/configure/interface/ethernet (1/0)# ip pim hello-
interval 145
To set the jp-timer to 30 seconds, enter:
Router/configure#ip pim jp-timer 30
To display information for all interfaces, enter:
Router# show ip pim sparse-mode interface or
Router# show ip pim sparse-mode interface detail or
Router# show ip pim sparse-mode bsr-router
© SAMSUNG Electronics Co., Ltd.
Ubigate iBG3026 Configuration Guide/Ed.00
127