Syntax Help
The CLI can complete the spelling of command or parameter keywords. Begin
typing the command or parameter then press TAB. At the CLI command
prompt type
Router# sh
Press TAB. The CLI shows:
Router# show
If the command or parameter partial spelling is ambiguous, the CLI displays
the choices that match the abbreviation. Type
shows:
Router# show interface
The interface displays 'show interface' and Type TAB once again then it
displays another parameter 'show ip.' Any available paramters can be fetched
by typing TAB.
Type ? and the CLI shows the list of parameters for the show interface
command.
Router# show interface ?
avc
Bundle
Bundles
Ethernet
Ethernets
l2tp-server
loopback
switchport
tunnel
tunnels
virtual-access display virtual access interface(s)
© SAMSUNG Electronics Co., Ltd.
:
sh
display information about an
DTE-to-DTE MFR avc
display information about a bundle
display all the names of bundles
Configured in the system
display an ethernet interface
display all ethernet interfaces
display l2tp-server interface(s)
display loopback interface(s)
Display the modes of the Layer2 interfaces
display a tunnel interface
display all tunnel interfaces
Ubigate iBG3026 Configuration Guide/Ed.00
. Press TAB. The CLI
show i
5