Samsung Ubigate iBG3026 Configuration Manual page 565

Step
1
2
3
4
5
6
7
© SAMSUNG Electronics Co., Ltd.
Command
voice-port slot/sub-
slot/port:ds0-group-
no
shutdown
calling-number
outbound range
string1 string2
calling-number
outbound sequence
[string1] [string2]
[string3] [string4]
[string5]
calling-number
outbound null
no shutdown
exit
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
To set up the attribute values of created ds0-
group, enter voice-port configuration mode.
Shuts down the voice port to manipulate
'timeslots' and 'signal cas' command.
Specifies ANI to be sent out when the T1-CAS
fgd-eana command is configured as signaling
type. The string1 and string2 arguments are
valid E.164 telephone number strings.
Only the last four digits are used for specifying
the range(string1 to string2) and for generating
the sequence of ANI by rotating through the
range until string2 is reached and then starting
from string1 again. If strings are less than four
digits in length, then entire strings are used.
Specifies ANI to be sent out when the T1-CAS
fgd-eana command is configured as signaling
type. This option configures a sequence of
discrete strings(string1...string5) to be passed
out as ANI for successive calls using the dial
peer or voice port. Limit is five(5) strings. All
strings must be valid E.164 numbers, up to 32
digits in length.
Suppresses ANI. No ANI is passed when this
voice port is selected.
Activate the voice port at the final step of
configuration
-
523