Chapter 7. Wan Interfaces; Module Configuration; Configuring T1 And E1 - Samsung Ubigate iBG3026 Configuration Manual

Ubigate iBG3026 Configuration Guide
CHAPTER 7. WAN Interfaces
Ubigate iBG3026 is available with T1, Channelized T3, and Clear Channel
DS3 WAN interfaces. Consult the Ubigate iBG3026 Installation Manual for
details on WAN interface types, cabling, and pinouts. This document outlines
the configuration of module parameters(Layer 1) and, to a lesser degree, the
configuration of bundle parameters(Layer 2). The bundle configuration
examples demonstrate linking of physical interfaces(modules) to logical
interfaces(bundles). Module configuration occurs within the configure module
tree of the Ubigate CLI, and bundle configuration occurs within the configure
interface bundle tree. The T1 and CT3 interfaces support logical interfaces
made up of fractional T1, single T1, and multi-link T1 connections.

Module Configuration

This section describes how to configure WAN interfaces of T1E1-2M, T1E1-4
and WT3-1C modules.

Configuring T1 and E1

The following shows simple steps to configure T1 and E1 interfaces
respectively.
Configuring T1 Module
The following steps sets a few communication modes and port information for
a T1 interface.
51
© SAMSUNG Electronics Co., Ltd.