Configuring Ripv2 Authentication - Samsung Ubigate iBG3026 Configuration Manual

Configuring RIPv2 authentication

The Ubigate iBG3026 provides RIPv2 authentication and the choice of a
single key or multiple keys for the authentication. This section describes a
simple example to configure RIPv2 authentication with a single key.
In this case, not only the network numbers but also the network interfaces
should be specified for authentication.
The following table shows the steps to enable RIPv2 authentication on a
Ubigate iBG3026 router.
Configuring Step
Step
1
2
3
4
5
6
7
8
9
© SAMSUNG Electronics Co., Ltd.
Command
Router# configure terminal
Router/configure# router rip
Router/configure/router rip# network
[interface]/[number of bit masks]
Router/configure/router rip# redistribute
connected
Router/configure/router rip# exit
Router/configure# interface [interface]
Router/configure/interface/[interface]# ip
rip
authentication mode {md5 | text}
Router/configure/interface/[interface]# ip
rip
authentication string [string]
Router # show ip protocols rip
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Enters the terminal
configuration mode.
Enters the RIP setup
mode.
Associates a network to
RIP.
Enables redistributing from
connected routes.
Returns to the upper level
prompt.
Specify the interface for
authentication
Selects authentication
mode.
Specify the authentication
string.
Displays RIP
configuration.
99