Samsung Ubigate iBG3026 Configuration Manual page 518

CHAPTER 30. Analog Voice Port
Step
9
10
11
12
13
476
Command
no shutdown
exit
dial-peer voice {pots | voip}
tag
Example)
/configure# dial-peer voice
pots 11
destination-pattern WORD
Example)
/configure# voice-port>
destination-pattern 1004
Purpose
ringing - Specifies the duration that the
voice port allows ringing to continue if a call
is not answered.
The range is from 0 to 60000.
The default is 180. 0 means infinity
wait-release - Specifies the duration that a
voice port stays in the call-failure state
while the device sends a busy tone, reorder
tone, or an out-of-service tone to the port.
The range is from 0 to 3600. The default is
30. 0 means infinity.
Change shutdown Status of voice-port to
in-Service
Exits voice port configuration mode
Enters dial-peer configuration mode and
defines a local dial peer that connects to a
POTS interface.
The number argument is one or more digits
identifying the dial peer. Valid entries are
from 1 to 10000.
The pots keyword indicates a dial peer
using basic
telephone service.
Setting Destination-pattern
Matches dialed digits to a telephony device.
The string argument is a series of digits
that specify the E.164 or private dialing
plan telephone number.
Valid entries are the numbers 0 through 9
and the letters A through D.
You can also enter the following special
characters:
- The asterisk (*) or pound sign (#) on
standard touch-tone dial pads can be
used anywhere in the pattern.
© SAMSUNG Electronics Co., Ltd.
(Continued)