Samsung Ubigate iBG3026 Configuration Manual page 405

Step
3 sip-ua
Example)
/configure/voip-gateway# sip-ua
4 [no] shutdown [forced]
Example)
/configure/voip-gatway/sip-ua# no
shutdown
5 exit
Example)
/configure/voip-gateway/sip-ua# exit
6 exit
Example)
/configure/voip-gateway# exit
Configuring Call Manager
This section describes the configuration necessary for interworking with Call
Manager. All calls of Ubigate iBG3026 in a Call Manager Inter-working mode
pass through Call Manager.
You can specify the SIP signaling IP Address and port of Call Manager using
ip-address command in a call-server configuration mode, and also specify
optionally the registration expire value in a Call Manager Inter-working mode.
The gw-uri command in a call-server configuration mode specify the URI
where a Ubigate iBG3026 will be registered in Call Manager, registration
expire value, and the interval of reattempt upon registration fail. Depending on
the registration status of the URI specified by gw-uri command, it is divided
into Call Manager Inter-working and Survivable Telephony mode.
You can make a setting which enables SIP registration in Call Manager per
dial-peer using register command in a dial-peer configuration mode.
Prerequisites for Call Manager Configurations
For interworking with Call Manager, the registration information of a relevant
Ubigate iBG3026 should be registered in advance. For more information, see
the Call Manager manual.
You should disable SIP service before setting the Call-server. You cannot set
the call server while SIP service is enabled.
© SAMSUNG Electronics Co., Ltd.
Command
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Enters sip-ua configuration mode.
Shuts down or enables voip call
services
Exits the current mode
Exits the current mode
(Continued)
363