Configuring Analog Fxs Voice Port - Samsung Ubigate iBG3026 Configuration Manual

Telephony signaling interface: Analog FXO, FXS or E & M
Locale Code(usually the country) for Call Progress Tone or DTMF/MF Variant
If FXO, type of Signal: loop-start or ground-start
If FXS, type of Signal: loop-start or ground-start or DID
If E & M, type: I, II, III, or V
If E & M, type of line: two-wire or four-wire
If E & M, type of start signal: wink, immediate, delay-dial
If E & M, type of Dialing: DTMF or MF

Configuring Analog FXS Voice Port

This section describes the configuration of analog FXS voice port.
How to Configure Analog FXS Voice Port
To set up each parameter of basic analog voice port, follow the next
procedures.
Configuration Steps
configure terminal
−
voice-port
−
dial-peer voice pots
−
exit
−
Detailed Steps
Step
1 configure terminal
Example)
# configure terminal
2 voice-port slot/subslot/port
© SAMSUNG Electronics Co., Ltd.
Command
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Enters global configuration mode.
Enter voice port Configuration Mode
slot - Specifies the number of the router
slot where the voice module in installed
subslot - Specifies the number of subslot
in the slot
port - Indicates the voice port
461