Samsung Ubigate iBG3026 Configuration Manual page 564

CHAPTER 31. Digital Voice Port
Step
4
5
6
7
Calling Number Outbound Settings
If T1 CAS is configured with the FGD-EANA signaling, the automatic
number identification(ANI) can be sent for outgoing calls by using the calling-
number outbound command.
FGD-EANA is a FGD signaling protocol of type EANA, which provides
certain call services, such as emergency(USA 911) calls. ANI is an a series of
digits in the call to identify the telephone number of the calling device.
In other words, ANI identifies the number of the calling party.
522
Command
define {tx-bits | rx-
bits} {seize | idle}
{0000 | 0001 | 0010 |
0011 | 0100 | 0101 |
0110 | 0111 | 1000 |
1001 | 1010 | 1011 |
1100 | 1101 | 1110 |
1111}
ignore {rx-a-bit | rx-b-
bit | rx-c-bit | rx-d-bit}
no shutdown
exit
Purpose
Defines specific transmit or receive signaling
bits to match the bit patterns required by a
connected device for North American E&M and
E & M MELCAS voice signaling, if patterns
different from the preset defaults are required.
Also specifies which bits a voice port monitors
and which bits it ignores, if patterns that are
different from the defaults are required.
tx-bits-Indicates the pattern applies to transmit
signaling bits.
rx-bits-Indicates the pattern applies to receive
signaling bits
seize-Indicates that the pattern represents line
seizure.
idle-Indicates that the pattern represents an
idle condition.
0000...1111-Represents the bit pattern to use.
Configures the voice port to ignore the
specified receive bit for North American E & M,
if patterns different from the defaults are
required.
Activate the voice port at the final step of
configuration
-
(Continued)
© SAMSUNG Electronics Co., Ltd.