Configuring Analog Fxo Voice Port - Samsung Ubigate iBG3026 Configuration Manual

CHAPTER 30. Analog Voice Port

Configuring Analog FXO Voice Port

This section describes the configuration of analog FXO voice port.
How to Configure Analog FXO Voice Port
To set up each parameter of basic analog FXO voice port, follow the next
procedures.
Configuration Steps
configure terminal
−
voice-port
−
dial-peer voice pots
−
exit
−
Detailed Steps
Step
1
2
3
4
468
Command
configure terminal
Example)
# configure terminal
voice-port slot/subslot/port
shutdown
signal {loop-start|ground-start}
Purpose
Enters global configuration mode.
Enter voice port Configuration Mode
slot - Specifies the number of the router
slot where the voice module in installed
subslot - Specifies the number of subslot
in the slot
port - Indicates the voice port
Change status of voice port to shutdown
Selects the access signaling type to
match that of the telephony connection
you are making. The keywords are as
follows:
loop-start - (default) Uses a closed circuit
to indicate off-hook status; used for
residential loops.
ground-start - Uses ground and current
detectors; preferred for PBXs and trunks
© SAMSUNG Electronics Co., Ltd.