Samsung Ubigate iBG3026 Configuration Manual page 516

CHAPTER 30. Analog Voice Port
Detailed Steps
Step
1
2
3
4
5
6
7
474
Command
configure terminal
Example)
# configure terminal
voice-port slot/subslot/port
shutdown
signal { wink-start |
immediate-start | delay-dial }
operation {2-wire | 4-wire}
dial-type {dtmf|mf}
locale locale
Purpose
Enters global configuration mode.
Enter voice port Configuration Mode
slot - Specifies the number of the router
slot where the voice module in installed
subslot - Specifies the number of subslot
in the slot
port - Indicates the voice port
Change status of voice port to shutdown
This command enables Direct Inward
Dialing on the voice port
immediate - if the voice port must use the
immediate start protocol
wink-start - if the voice port must use the
wink-start protocol
delay-dial - if the voice port must use the
delay start protocol
Specifies the number of wires used for
voice transmission at this interface(the
audio path only, not the signaling path)
Specifies the dialing method for outgoing calls
Selects the two-letter locale for the voice
call progress tones and other locale-
specific parameters to be used on this
voice port
The Default is us
ex) locale us
© SAMSUNG Electronics Co., Ltd.