CHAPTER 19. QoS
Configuration Example
Router/configure/interface/ethernet (3/0)/qos# mark-dscp 10
Router/configure/interface/ethernet (3/0)/qos# no mark-dscp
Router/configure/interface/ethernet (3/0)/qos# mark-up 3
Router/configure/interface/ethernet (3/0)/qos# no mark-up
Router/configure/interface/ethernet (3/0)/qos# override-outq
2
Router/configure/interface/ethernet (3/0)/qos# no override-
outq 2
Verifying the Configuration
Use the following command to verify the configuration:
show qos port-info ethernet3/0
Policy Based CoS Marking
Policy-based CoS marking assigns CoS attributes based on traffic flows
identified by match rules. Policy-based CoS marking can be achieved though
the configuration of policies(rules and actions) and interface-to-policy
mappings.
To create a policy map, enter:
Router/configure/qos# policy-map <map-name>
To create a policy class, enter:
Router/configure/qos/policy-map <map-name># policy-class
<classname>
To create a policy rule, enter:
Router/configure/qos/policy-map <map-name>/policy-class
<classname># match ipv4 src-ip 20.20.20.20
206
© SAMSUNG Electronics Co., Ltd.