Samsung Ubigate iBG3026 Configuration Manual page 473

Configuring Basic H.323 Services
This section describes how to do a configuration to enable H.323 gateway to
perform a basic call processing.
Prerequisites for Basic H.323 Services
The followings should be done first before setting the configuration to enable
H.323 gateway to perform a basic call processing.
H.323 services should be already enabled.
A routing plan for POTS/VoIP call should already be established.
The POTS side configuration of H.323 gateway should be set normally.
Indirect Connection where H.323 gateway is managed by a gatekeeper.
How to Configure Basic H.323 Services
To set a configuration enabling H.323 gateway to perform a basic call
processing, it should be done in a 'dial-peer voice voip' configuration mode,
in the following way.
Configuration Steps
configure terminal
−
dial-peer voice voip
−
destination-pattern
−
session protocol
−
session target
−
codec or voice-class codec
−
voice-class h323
−
exit
−
Detailed Steps
Step
1
2
© SAMSUNG Electronics Co., Ltd.
Command
configure terminal
Example)
# configure terminal
dial-peer voice voip tag
Example)
/configure# dial-peer voice voip 100
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
Enters global configuration mode.
Enters dial-peer configuration mode
for the VoIP peer designated by tag.
431