Samsung Ubigate iBG3026 Configuration Manual page 621

Hide thumbs Also See for Ubigate iBG3026:

Table of Contents

Figure 33.8 Relationship Between Destination Pattern and Session Target

Session target is used for inbound matching. When Voip incoming does not

match due to number condition, try matching the set session target and the ip

Voip-peer has protocol type and ip-address. To designate a network-specific

address to receive calls from a VoIP dial peer in addition to use session target

ip-address command, use the session target name command in dial-peer

configuration mode. The type of voip-peer should be consistent with the

session protocol type of dial-peer. Sip-server, gatekeeper can not be

configured in voip-peer. Voip-peer could be used in not only dial-peer but also

gatekeep, sip-server, call-server, mwi-server or registrat-server.

Following is the example of configuration.

voip-peer voippeer1 sip

ip-address ipv4:10.254.139.56

Incoming Called Number & Answer Address for VoIP

'Incoming-called-number' command is the top priority attempting inbound

dial-peer matching by comparing the called number of incoming call.

If different setup on the call bound for the particular called number is tried,

inbound dial-peer matching of the pertinent call is possible by using this

command. Even though there is matchable dial-peer, matching according to

the condition of incoming called number occurs first.

VoIP dial peer

session target

Ubigate iBG3026 Configuration Guide/Ed.00

VoIP dial peer

destination target

Ethernet port

Show Quick Links

Chapters

Table of Contents