Samsung Ubigate iBG3026 Configuration Manual page 548

CHAPTER 31. Digital Voice Port
Voice Volume Adjustment
It is recommended that voice volume may be uniform as possible when
subscriber makes a call through a packet voice network, but in some countries,
adjusting input or output volume may be required depending on kinds of
network equipment. To provide this kind of gain adjustment function on the
network, it supports the command, input gain and output attenuation
At this time, an user should be cautious in setting, setting input/output gain
wrong may affect greatly voice quality. For example, if you set up too high
input gain, the receiver get the voice disconnected or loud around, otherwise
setting too low input gain may cause the receiver get too low to hear.
Step
1
2
3
4
5
6
Jitter Adjustment
In order to compensate variable-length voice delay, it sets up the method to
cope with packet jitter depending on the features of packet network whose
voice connection is made. The call route on IP side in case of VoIP call is
determined by dial peer. From this reason, the features of IP network can be
well known, and in which proper setup is most optimal. Accordingly, initial
setup and control of dynamic jitter buffer in order to cope with voice delay is
executed on the basis of information configured in dial peer, and set up with
the command playout-delay.
506
Command
configure terminal
dial-peer voice voip num
digital-gain input vauel
digital-gain output value
Exit
show voice port
slot/sub-slot/port:ds0-
group-no
Purpose
Enter the global configuration mode.
Enter the dial-peer configuration mode.
Sets the PCM-to-encoder input gain, in
decibels ranging from-13.9 to 6.0.
The changes take effect at the next trial of
voice connection
Sets the decoder-to-PCM output gain, in
decibels ranging from-13.9 to 6.0. The
changes take effect at the next trial of voice
connection.
Exit the voice-port configuration mode.
checks out if the values set up in the voice
port are set up normally.
© SAMSUNG Electronics Co., Ltd.