Samsung Ubigate iBG3026 Configuration Manual page 522

CHAPTER 30. Analog Voice Port
Step
6
7 timing wink-wait timer-value
8 timing wink-duration timer-value
9 timing delay-duration timer-value
10 timing delay-start timer-value
11 no shutdown
480
Command Purpose
The range is from 0 to 60000.
The default is 180. 0 means infinity.
wait-release - Specifies the duration that
a voice port stays in the call-failure state
while the device sends a busy tone,
reorder tone, or an out-of-service tone to
the port.
The range is from 0 to 3600. The default
is 30. 0 means infinity.
Sets the maximum time to wait before
sending wink signal after an incoming
seizure is detected
Sets the duration of a wink-start signal
Sets the duration of a delay signal
Sets the delay interval after a incoming
seizure in detected
Change shutdown Status of voice-port to
in-Service
© SAMSUNG Electronics Co., Ltd.
(Continued)