Configuring Analog E & M Voice Port - Samsung Ubigate iBG3026 Configuration Manual

Step
14
15 port slot/subslot/port
16 exit
Configuring Analog E & M Voice Port
This section describes the configuration of analog E&M voice port.
How to Configure Analog E&M Voice Port
Unlike FXO, FXS, E & M voice port is not enough to send voice data as a
default value, the set up values of E&N voice port should be sure to be
matched with the features of PBX unit interworked.
Two-wire or Four-wire Jumper Setting
A user should set up Cabling scheme pertinent to Analog E & M voice port of
Submarine in Jumper setting.
2-wire
PIN Number
1
2
3
4
5
6
7
8
© SAMSUNG Electronics Co., Ltd.
Command
4-wire
Signal PIN Number
SB 1
M 2
- 3
RING 4
TIP 5
- 6
E 7
SG 8
Figure 30.7 E & M 2-Wire, 4-Wire loop Cable Pin Map
Ubigate iBG3026 Configuration Guide/Ed.00
Purpose
- The period (.) acts as a wildcard character.
When the timer(T) character is included at
the end of the destination pattern, the router
collects dialed digits until the interdigit timer
expires(5 seconds, by default) or until you
dial the termination character(the default is
#). The timer character must be a capital T.
Maps the dial peer to a specific Port Number
Exits voice dial-peer configuration mode
Signal
E & M Type
SB
Type 1
M
Type 2
RING
Type 3
RING
Type 5
1
TIP 1
E & M
TIP
2-wire
E
4-wire
SG
(Continued)
J6/J7 J4/J5
3-4 2-3
1-2 1-2
1-2, 3-4 1-2
3-4 2-3
J1/J2 J11/J12
(CH0) (CH1)
1-2 1-2
2-3 2-3
471