Replacing The Staple Cartridge (For C-Finisher Or C-Finisher With Booklet Maker) - Xerox ApeosPort-II 5010 User Manual

14 Maintenance
Replacing the Staple Cartridge (For C-Finisher or C-Finisher with Booklet
Maker)
When the C-Finisher (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When the message appears, load a new
staple case into the staple cartridge.
This section explains how to replace the staple cartridge attached with the C-Finisher
with Booklet Maker. Use the same procedure for the C-Finisher.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
Note
1
Make sure that the machine has
stopped, and open the front cover
of the finisher.
2
Grip the lever R1 of the staple
cartridge holder, and pull out the
14
holder to the right, towards you.
3
Take out the staple cartridge holder
by gripping the orange lever.
Note
4
Pick the empty staple case with
your fingers (1), and then remove
the case from the cartridge (2) as
shown in the figure.
414
performance. Use only staple cartridges recommended by Fuji Xerox.
• To order a new staple cartridge, contact our Customer Support Center.
• The staple cartridge is firmly
inserted. When taking the
staple cartridge out of the
machine, strongly pull it out.
Lever (R1) Lever (R1)
Orange lever
2
1
1