6E2–62
RODEO 6VD1 3.2L ENGINE DRIVEABILITY AND EMISSIONS
A/C Clutch Control Circuit Diagnosis (Cont'd)
Step
39
Check for a damaged pin or terminal at B-14 of the
PCM.
Was a damaged pin or a terminal found?
40
1. A/C compressor relay removed.
2. Connect a fused jumper at the A/C compressor
relay socket between either BRN wire and the
BRN/YEL wire.
3. Engine idling.
4. A/C "ON."
5. Blower "ON."
Did the compressor magnetic clutch engage?
41
Repair the A/C compressor relay.
Is the action complete?
42
Check for an open circuit between the A/C compressor
relay and the A/C clutch.
Was an open circuit found?
43
Repair the open circuit between the compressor Clutch
and the A/C compressor relay.
Is the action complete?
44
Service the compressor clutch or replace the
compressor due to a faulty internal overheat switch.
Is the action complete?
45
1. Remove the A/C compressor relay.
2. Idle the engine.
Is the compressor clutch still engaged when A/C is not
selected?
46
Repair the short to voltage between the A/C clutch and
A/C compressor relay.
Is the action complete?
47
1. Reinstall the A/C compressor relay.
2. Remove the A/C thermostat relay.
3. Engine idling.
Is the compressor clutch still engaged when A/C is not
selected?
48
Use a DVM to check for a short to ground between the
A/C compressor relay and B-14 of the PCM.
Was a short detected?
49
Repair the short to ground between the PCM and A/C
compressor relay.
Is the action complete?
50
Repair the short to ground between the A/C thermostat
relay and the electronic thermostat.
Is the action complete?
Action
Value(s)
Yes
—
Go to Step 32
—
Go to Step 41
—
Verify repair
—
Go to Step 43
—
Verify repair
—
Verify repair
—
Go to Step 46
—
Verify repair
Go to Step 48
—
—
Go to Step 49
—
Verify repair
—
Verify repair
No
Go to Step 33
Go to Step 42
—
Go to Step 44
—
—
Go to Step 47
—
Go to Step 50
Go to Step 33
—
—