Print End Position - SATO GL408e Programming Reference Manual

PRINT AREA, ENLARGEMENT
FUNCTION Specifies the print area to be standard height of 178 mm or enlarged to 356 mm.
FORMAT
<ESC>AR
<ESC>AX
Place after <ESC>A within the data stream.
EXAMPLE <ESC>A
<ESC>AR
<ESC>Z
OUTPUT
(4-37)
NOTES This command changes the print area of pitch direction.
Insert this command after Start of Data Transmission (<ESC>A). To return to the
standard print area, power off the printer to cancel the command.

PRINT END POSITION

FUNCTION
Changes the label stop position in the sensor invalid mode.
FORMAT <ESC>EP
Place after <ESC>A within the data stream.
EXAMPLE
<ESC>A
<ESC>EP
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
None.
SATO GL4xxe SBPL Programming Reference
Standard print area
Enlarged print area
Unit 4: Standard Command Codes
Page 4-52