Loading Media; Loading Fan-Fold Media - SATO SG112-ex Operator's Manual

3.4 Loading Media

Use consumables from our specified suppliers on the product, for optimum print quality.
CAUTION
• The print head and its surroundings are hot after printing. Be careful not to touch it, to avoid being burned.
• Touching the edge of the print head with your bare hand could cause injury.
Note
The usable media sizes, the output speed and print quality vary depending on the media specification, media
and ribbon combination, product settings and outputting environment. It is recommended to perform a test
print with the media and ribbon to be used in advance.
3.4.1

Loading Fan-fold Media

1
Loosen the media guide thumb screws 
on the back of the product.
2
Adjust the media guide  of both sides
with both hands to fit the width of the
media.
3
Press the power switch on the operator
panel to "I" position.
Note
If Paper end error occurred, open the top cover and
the print head assembly. Make sure that there is no
media left in the media path. Then close the print head
assembly and the top cover.
The display on the operator panel changes to offline
mode.
CAUTION
When closing the top cover or the print head
assembly, be careful not to pinch your fingers.
3 Loading the Ribbon and Media
1
2
On Off
SG112-ex Operator Manual
47