Adjusting The Media Stop Position For Option - SATO SG112-ex Operator's Manual

5 Adjusting the Product
3
Change the setting value. Press the
/ buttons to set the desired value.
Set the offset value with '+' to move the print
position opposite the feed direction, and value
with '-' to move the print position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01")
regardless of print resolution.
The setting range is from -3.75 mm (-0.15") to
+3.75 mm (+0.15").
4
Press the ENTER button to save the
setting and go to the next adjustment
screen.
5.4.3

Adjusting the Media Stop Position for Option

Adjustment Location
Adjustment Mode: Offset Position
The stop position for options (such as cutter) is adjustable within the range of +3.75 mm to -3.75 mm
(+0.15" to -0.15") in the
Note
• The above cut position for printing indicates the media stop position when the media sensor type is set to
Gap.
• You can also adjust when the operation mode is specified to Tear-off.
148
SG112-ex Operator Manual
Adjustment Mode.
Media feed direction
Adjustment for
"+" value
No
adjustment
Adjustment for
"-" value
Adjustment Range
+3.75 mm to -3.75 mm (+0.15" to -0.15")
Base reference
point for printing
Cut position (Print head)
36.2 mm
(14.3")
-3.75 mm (-0.15") ~ +3.75 mm (+0.15")