Maintenance Of Print Head And Platen Roller; Maintenance With The Cleaning Kit - SATO Cl4NX Operator's Manual

5 Cleaning and Adjustment of the Printer

5.2 Maintenance of Print Head and Platen Roller

The maintenance timing is as follows:
• After you print one media roll or print media for one hundred and fifty meters
Use the cleaning kit to clean these parts:
• Print head
• Media sensors
• After you print six media rolls or print media for nine hundred meters
Use the cleaning sheet to clean these parts:
• Print head
Use the cleaning kit to clean these parts:
• Media guide
• Media route
• Others
Note
The above maintenance timing is only for reference. Do the cleaning if necessary.
5.2.1

Maintenance with the Cleaning Kit

The procedures of the maintenance with the cleaning kit are as follows:
Note
For the details of the cleaning kit, refer to the manual attached to the cleaning kit.
1
Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2
Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
172
CL4NX Operator Manual
• Platen roller
• Media guide
• Platen roller
• Feed roller
• Ribbon route