Selecting The Label Sensor Type - SATO CX Series Service Manual

1-6 Printer Setup
Loading Ribbon (Continued)
LOWER THE PRINT HEAD
AND PRESS DOWN FIRMLY
ON BOTH HEAD LATCHES
TO LOCK THE PRINT HEAD
IN POSITION

Selecting the Label Sensor Type

CX200 printers support Eye-Mark, gap, or notch label sensing. The printer must be
set for the proper sensing method. If you are using label printing software, it should
provide a means to set up these parameters. See your software documentation for
details. If you are writing your own software or controlling the printer using direct
commands, you must use printer commands to set up the print mode and sensing
method. Refer to the programming manual.
All manuals and user guides at all-guides.com
SECTION 1 - GENERAL INFORMATION
SATO SERVICE MANUAL
CX Series Printers
TURN RIBBON TAKE-UP
KNOB CLOCKWISE TO
ELIMINATE RIBBON
SLACK
15
Rev B