Fitting Bracket Assembly Replacement - Sony HDW-750 Maintenance Manual

6-11. 50P Fitting Bracket
Assembly Replacement
Removal
1. Remove the three screws (P2 x 4) and
remove the spacer.
2. Loosen the precision screw (with drop-safe)
and remove the connector cover assembly.
3. Remove the three screws (B3 x 8) and
remove the V mounted assembly.
4. Remove the five precision screws (P2.6 x 5).
While removing the 50P fitting bracket
assembly, disconnect the flexible card wires
from the connectors (CN601, CN602) on the
CI-27 board (CI-32 board).
n
Life of flexible card wire will be significantly
shortened if it is folded. Be very careful not
to fold the flexible card wire.
Installation
5. Align the position-setting hole of the new
50P fitting bracket assembly with the posi-
tion-setting pin of the frame. Install it with
the five precision screws (P2.6 x 5).
Standard tightening torque :
53 x 10 _2
N.m (5.3 kgf.cm)
6. Align the position-setting hole of the V
mounted assembly with the position-setting
pin of the frame. Install it with the three
screws (B3 x 8).
Standard tightening torque :
80 x 10 _2
N.m (8 kgf.cm)
7. Install the connector cover assembly and
spacer by reversing the steps of removal.
HDW-750/750CE V1
6-11. 50P Fitting Bracket Assembly Replacement
Connector cover assembly
Precision screw
(with drop-safe)
Position-setting pin of
the 50P fitting
bracket assembly
Position-setting pins
of the V mounted
assembly
Position-setting
hole
50P fitting bracket
assembly
Flexible card wires
Spacer
P2 x 4
CI-27 board
(CI-32 board)
CN601
CN602
Precision screws
P2.6 x 5
Position-
setting holes
B3 x 8
V mounted assembly
6-21