Warm-Up Time; Fpot (First Print Output Time); Continuous Printing Speed - Dell 3010CN Service Manual

4.7 Warm-up Time

When nominal voltage (100V, 115V, 220V) is applied, the printer will proceed to standby mode from
POWER-ON within 37 seconds.
Reference: Measured at 22°C, 55% RH, nominal voltage.

4.8 FPOT (First Print Output Time)

FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the PRINT indication is given is
calculated on the following conditions (rounded to one decimal place).
• IOT performance that the controller does not have IOT wait.
• The printer is in the standby mode. (ROS MOTOR OFF, FUSER READY)
• Paper is A4 or Letter SEF
• Except when process control is operating*1
*1:Process controller operation is process controls such as TC control, electric potential control,
cleaning cycle, registration control, and so on. Sometimes, the engine stops feeding papers for
a certain period of time while continuous printing for these operations.
OS PDL
XP Like a GDI
XP Like a GDI

4.9 Continuous Printing Speed

The continuous printing speed is shown in the below.
OS PDL
XP Like a GDI
XP Like a GDI
measurment
Paper SIZE
chart
J9E A4/Letter SEF Normal paper
J9E A4/Letter SEF Normal paper
measur-
Paper SIZE
ment chart
J11E A4/Letter SEF Normal paper
J11E A4/Letter SEF Normal paper
Paper
Paper is
Paper
fed to ;
MPF
MPF
8 – 8
Chapter 8 Printer Specifications
Paper is Color
fed to i mode
MPF F/C
MPF B/W
Color duplex/
mode siplex
F/C siplex
B/W siplex
FPOT
≤
25
≤
16
FPOT
≤
158
≤
45