Table of Contents
Advertisement
RRP5.11 MOTOR-PH (PL 5.2.20)
[Removal]
1)
Remove VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
2)
Release the two hooks that fix COVER-HARNESS to VERTICAL TRANSPORT ASSEMBLY
(PL 5.2.1) and remove COVER-HARNESS.
3)
Release a clamp on GEAR ASSY DRIVE (PL 5.2.24), and remove the harness of MOTOR-PH
(PL 5.2.20) from the groove of VERTICAL TRANSPORT ASSEMBLY.
4)
Remove the two screws (silver, with a flange, 6mm) that fix MOTOR-PH to VERTICAL
TRANSPORT ASSEMBLY.
5)
Remove MOTOR-PH from VERTICAL TRANSPORT ASSEMBLY.
[Replacement]
Pay attention to the fitting direction of MOTOR-PH when carrying out the work shown
below.
1)
Attach MOTOR-PH to VERTICAL TRANSPORT ASSEMBLY in such a direction that harness
of MOTOR-PH comes to the front.
2)
Fix MOTOR-PH on VERTICAL TRANSPORT ASSEMBLY using two screws (silver, with a
flange, 6mm).
3)
Lay the harness of MOTOR-PH to the groove of VERTICAL TRANSPORT ASSEMBLY, and
fix it using a clamp on GEAR ASSY DRIVE.
4)
Match the boss and the convex of COVER-HARNESS to the hole of VERTICAL TRANSPORT
ASSEMBLY and fix it using two hooks.
5)
Attach FRAME-ASSY-PH. (RRP 5.3)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 179
Advertisement
Chapters
Table of Contents
