Table of Contents
Advertisement
RRP4.10 ACTUATOR (PL 4.1.22)
[Removal]
1)
Remove COVER ASSY RH. (RRP 1.12)
2)
Remove LEFT COVER. (RRP 1.10)
3)
Remove MULTIPURPOSE FEEDER COVER. (RRP 1.7)
4)
Remove LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
5)
Remove VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
6)
Remove MULTIPURPOSE FEEDER ASSEMBLY. (RRP 4.1)
7)
Remove LEFT SIDE GUIDE and RIGHT SIDE GUIDE. (RRP 4.4)
Do not need to disconnect the connector of PHOTO SENSOR when carring out the work
shown below.
8)
Remove PHOTO SENSOR. (RRP 4.9)
9)
Spread right and left fitting parts of PLATE BOTTOM 2 (PL 4.1.12) from PLATE BOTTOM
ASSY MSI (PL 4.1.13) and remove the hole of PLATE BOTTOM 2 from the boss of PLATE
BOTTOM ASSY MSI.
10) Rotate PLATE BOTTOM 2, remove the right and left boss of PLATE BOTTOM 2 from notched
of MULTIPURPOSE FEEDER ASSEMBLY (PL 4.1.1) and remove PLATE BOTTOM 2.
Pay attention so that ACTUATOR is not broken when carrying out the work.
11) Remove groove of left shaft of ACTUATOR (PL 4.1.22) from a hook of MULTIPURPOSE
FEEDER ASSEMBLY, and remove right shaft of ACTUATOR from the hole in
MULTIPURPOSE FEEDER ASSEMBLY.
12) Move ACTUATOR to left side to move the shaft of ACTUATOR along with the notched of
MULTIPURPOSE FEEDER ASSEMBLY and remove ACTUATOR.
[Replacement]
1)
Slide in the actuator of ACTUATOR between the gap of MULTIPURPOSE FEEDER
ASSEMBLY, move the shaft of ACTUATOR along with the notched of MULTIPURPOSE
FEEDER ASSEMBLY and attach ACTUATOR.
2)
Place the right shaft of ACTUATOR in the hole in MULTIPURPOSE FEEDER ASSEMBLY
and fix the groove of left shaft of ACTUATOR to a hook of MULTIPURPOSE FEEDER
ASSEMBLY.
Be sure to match ACTUATOR to the hook.
3)
Lift PLATE BOTTOM 2 at 90 degrees, place the right and left boss parts in the notched of
MULTIPURPOSE FEEDER ASSEMBLY and attach PLATE BOTTOM 2.
4)
Spread fitting parts at right and left sides of PLATE BOTTOM 2, place the hole of PLATE
BOTTOM 2 in the boss of PLATE BOTTOM ASSY MSI and attach PLATE BOTTOM 2.
5)
Attach PHOTO SENSOR. (RRP 4.9)
6)
Attach LEFT SIDE GUIDE and RIGHT SIDE GUIDE. (RRP 4.4)
7)
Attach MULTIPURPOSE FEEDER ASSEMBLY. (RRP 4.1)
8)
Attach VERTICAL TRANSPORT ASSEMBLY. (RRP 5.3)
9)
Attach LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
10) Attach MULTIPURPOSE FEEDER COVER. (RRP 1.7)
11) Attach LEFT COVER. (RRP 1.10)
12) Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 148
Advertisement
Chapters
Table of Contents
