Dell 3010CN Service Manual page 90

Clutch and Solenoid name
(Diag. Code)
Tray 2 Solenoid (DO-dc)
NOTE: Tray 2 Solenoid is in the 250 or 500 sheets Option
Tray.
1) Turn on the power and enter the Diagnostic Mode.
2) Execute the DO-dc. Upon hitting the "
noise of the solenoid will be heard.
3) Press the "Cancel" key to stop the solenoid.
Combination test is as follows.
NOTE: The Roller rotates once when the DO-dc and the DO-
e8 are executed. Before executing the combination test,
remove the Paper Cassette and left side cover of the paper
tray. This procedure is for the technical staff.
1) Turn on the power and enter the Diagnostic Mode.
2) Execute the DO-dc and the DO-e8. Confirm the roll rotation from
the front side of the Tray.
3) Press the "Cancel" key to stop the motor.
4) Press the " " key to display the DO-dc.
5) Press the "Cancel" key to stop the solenoid and reseat the Paper
Cassette.
2 - 63
Chapter 2 Operation of Diag.
Confirmation procedure
Tray 2 Solenoid
" key, the operating
Leg_Sec02_068FA